Use 5/16' studs but with flat nuts as opposed to T nuts. Go with the 1/4' studs and just use a couple of larger washers to spread the load.Ģ. I can see a couple of way round this but not sure what the best method would be from.ġ. I've knocked up some tee nuts but when used with the 1/4' studs they just don't look meaty enough to hold my 5' vice securely. I have an old Elliott Juniormil which although it has a 28' x 7' table has ridiculously small tee slots, the narrowest part being only 5/16 wide. I need some advice about the best way to clamp down my vice on the milling machine.
